60
 
Advanced Setup
 
—Continued
 
Equalizer Settings
 
Here you can adjust the tone of individual speakers. To 
set the volume of individual speakers, see page 59.
 
Notes:
 
• The front, center, surround, and surround back speak-
ers can be adjusted at 
80 
 Hz, 250 Hz, 800
 
Hz, 
2500 Hz, and 8000 Hz. The subwoofer can be adjusted 
at 40 Hz, 80 Hz, and 160 Hz.
• While the Direct or Pure Audio listening mode is 
selected, the equalizer settings have no effect.
• This procedure can also be performed on the AV 
receiver by using its [SETUP], [ENTER], and arrow 
buttons.
 
1
 
Press the [RECEIVER] REMOTE 
MODE button, followed by the 
[SETUP] button.
 
2
 
Use the Up and Down [ ]/[ ] 
buttons to select “Equalizer,” and 
then press [ENTER].
 
3
 
Use the Left and Right [ ]/[ ] 
buttons to select:
 
Off: 
 
Tone off, response flat.
 
Audyssey: 
 
The tone for each speaker 
is set automatically by the 
Automatic Speaker Setup 
function. Be sure to select 
this setting after having 
performed the Automatic 
Speaker Setup.
 
Manual: 
 
You can adjust the equal-
izer for each speaker 
manually.
If you selected Manual, continue with 
this procedure. If you selected Off or 
Audyssey, go to step 7.
 
4
 
Press the Down [ ] button, and 
then use the Left and Right 
[ ]/[ ] buttons to select a 
speaker.
These settings are set automatically by the Automatic 
Speaker Setup function (see page 35).
SETUP
RECEIVER
 
5
 
Use the Up and Down [ ]/[ ] 
buttons to select a frequency. 
Use the Left and Right [ ]/[ ] 
buttons to adjust the level at that 
frequency.
 
The volume at each frequency can be 
adjusted from –6 to +6 dB in 1 dB 
steps.
 
Tip:
 
 Low frequencies (e.g., 80 Hz) 
affect bass sounds; high frequencies 
(e.g., 8000 Hz) affect treble sounds.
 
6
 
Use the Up [ ] button to select 
“Ch,” and then use the Left and 
Right [ ]/[ ] buttons to select 
another speaker.
 
Repeat steps 5 and 6 for each speaker.
Speakers that you’ve set to No or None 
in the Speaker Configuration (page 56) 
cannot be selected.
 
7
 
Press the [SETUP] button.
 
The setup menu closes.
SETUP
TX-SR505En.book Page 60 Tuesday, January 30, 2007 11:53 AM