To Next PageTo Next Page
Need help?Do you have a question about the Onkyo TX-SR503 and is the answer not in the manual?
General| Channels | 7.1 |
|---|---|
| Power Output | 75 W per channel (8 ohms, 20 Hz-20 kHz, 0.08% THD) |
| HDMI Inputs | 0 |
| HDMI Outputs | 0 |
| Response Bandwidth | 10 Hz - 100 kHz |
| Signal-To-Noise Ratio | 100 dB |
| THD | 0.08% |
| Input Impedance | 47 kOhm |
| Input Sensitivity | 200 mV |
| Audio D/A Converter | 192 kHz/24-bit |
| Surround Sound Effects | Theater-Dimensional |
| Tuner Presets | 40 |
| Width | 435 mm |
| Frequency Response | 10 Hz - 100 kHz |
| Speaker Impedance | 6 - 16 Ohm |
| Audio Formats | Dolby Digital, DTS, Dolby Pro Logic II |
| Amplifier Output Details | 75W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
| Tuning Display | Fluorescent |
| Video Inputs/Outputs | Composite |
| Digital Audio Inputs | Optical, Coaxial |
| Analog Audio Inputs | RCA |
Components marked with a symbol are critical for fire and electric shock risk.
Instructions on replacing fuses, emphasizing using the correct type for fire hazard protection.
Procedure for checking speaker protection status via DC voltage detection.
Procedure for checking speaker protection status via current detection using dummy loads.
Procedures for checking output sensor and thermal sensor functions.
Detailed circuit diagrams for the power amplifier and speaker terminal sections.
Block diagram, pin layout, and detailed terminal descriptions for the CS494003CQZ audio decoder IC.
Block diagram and detailed terminal descriptions for the CS42518 audio codec IC.
Detailed descriptions of the M30622MGP microprocessor pins (Part 1 & 2).
Step-by-step guide for adjusting the idling current, including diagrams and specifications.
