6
Positioning the XM Passport System
You can check the signal strength of the XM radio signal
and adjust the position of the XM Passport System
accordingly.
XM Radio Messages
The following messages may appear while using XM
radio.
❑
CHECK ANTENNA
The XM Passport System is not connected properly.
Check the connection.
❑
UPDATING
The XM user encryption code is being updated. Please
wait.
❑
NO SIGNAL
The signal is too weak. Check the XM Passport System
connection and reposition it for the best reception.
❑
LOADING
The AV receiver is tuning or decoding audio or text data.
Please wait.
❑
OFF AIR
The XM channel you selected is not currently broadcast-
ing. Select another channel.
1
On the AV receiver, press the
[SETUP] button.
2
Use the TUNING Up and Down
[ ]/[ ] buttons to select “7. ANT
Aiming,” and then press
[ENTER].
3
Adjust the position of the XM
Passport System so that the SAT
signal strength bar is as long as
possible.
If you can’t receive a satellite signal,
press the Down [ ] button to display
the terrestrial (TER) signal strength
meter and adjust your XM Passport
System so that the bar is as long as pos-
sible.
Terrestrial
signals are only available in
certain areas.
So long as the signal strength is good,
you can enjoy XM Radio by using
either satellite or terrestrial reception.
MASTER VOLUME
VIDEO
STANDBY
TONE
DISPLAYSTEREO DIMMER MEMORY
DIGITAL
INPUT
TUNING
MODEAB
SPEAKERS
TUNERTAPE
VIDEO
3VIDEO 2VIDEO 1
VCR
DVDMULTI CH C
D
SETUPRETURN
CLEAR
LISTENING MODE
AUDIOLR
VIDEO 3 INPUT
STANDBY/ON
PHONES
TUNING PRESET
ENTER
SETUP
TUNINGENTER
SETUP
TUNING PRESET
XM574En Page 6 Tuesday, June 20, 2006 9:07 AM
To Next Page
Loading...
