V1.1-ENG
9 www.onlab.com.tr
LEARNING THE DOOR
After initial power-up of the Ondrive device at the first time, “Learn the door” warning will
be seen on LCD screen in Inspection mode and it will not be possible to operate the device to
open or close the door without the completion of “door learning” process.
To learn the door, it is enough to press “DOWN” button in Inspection mode after setting the
parameters given in previous chapters. At that case, firstly the door will move to opening
direction and then it will move to closing direction. After the completion of skate closing,
door learning process will end. After this, by pressing ESC button, the device will enter to
Normal Operation Mode.
In door learning process, firstly the door should move to opening direction and then it
should move to closing direction. If in door learning process, the door starts to move
closing direction firstly, please navigate the menu to “Manufacturer Settings” and change
the value of “Motion Direction” parameter in menu 41 to “Inverted”. Then press ESC and
ENTER buttons consecutively and return to Inspection mode. At that mode start learning
process again by pressing DOWN button.
To Next Page
Loading...
Need help?
General