Lap Belt
The center passenger position has a lap safety belt with no
retractor. Follow these instructions to wear it properly:
1. Pull the latch plate as you tilt and extend the belt.
2. Push the latch plate into the buckle until it clicks.
Make sure the release button on the buckle faces
upward or outward.
3. To tighten the belt, hold the buckle and pull on
the slack.
To unlatch the belt, press the button on the buckle.
Replacing Safety Belts
If you have been in a collision where the belts may have
been stretched, or if the safety belt is cut or damaged,
the belt needs to be replaced. Repairs may be necessary
even if the safety belt was not used at the time of
the collision. Have the restraint system inspected
after a collision.
2-8
To Next Page
Loading...
