1. To remove your jack cover, pull up on the latch at
the end of the cover, near the endgate and the latch
on the top of the cover.
2. Remove the wheel blocks, jack and wheel wrench.
3. To remove the
underbody-mounted
spare, insert the
chisel end of the
wheel wrench, on an
angle, into the gole
in the rear bumper.
Be sure the chisel
end of the wheel
wrench connects into
the hoist shaft.
NOTICE:
Never remove or restow a tire from/to a stowage
position under the vehicle while the vehicle is
supported by a jack. Always tighten the tire fully
against the underside of the vehicle when
restowing.
5-10
To Next Page
Loading...
