Opel CD 70 - Operation

78 Introduction
3 p button ............................ 101
Switch between radio and
CD mode ............................. 101
Radio: Discontinue TA and
PTY31 messages .................. 88
If a DAB receiver is
connected: changing
between analogue and
digital reception and CD
mode ..................................... 88
4 c button ................................. 88
Radio: search down, scroll
back through station
memory ................................. 88
Discontinue TA and
PTY31 messages ................. 88
CD: Skip one track
backwards, fast reverse
station memory ................... 101
5 d button ................................. 88
Radio: search Radio:
search up, scroll forwards
through station memory ........ 88
Discontinue TA and
PTY31 messages ................. 88
CD: Skip one track
forwards, fast forward ......... 101
6 Turn: adjust volume .............. 76
Operation
Control elements
The Infotainment system is operated
via function buttons, multifunctional
knobs and menus that are shown on
the display.
Inputs are made optionally via:
■ the central control unit in the
instrument panel 3 76
■ controls on the steering wheel
3 76.
Switching the Infotainment
system on or off
Press the e knob.
The audio source last set is played.
Switching on and off with the ignition
key (automatic switch-on)
If the automatic switch-on is enabled,
the Infotainment system can also be
switched off and on again via the
ignition.
This link between the radio and
ignition is preset in the factory, but this
can be disabled.
■ If the automatic switch-on is
disabled, the Infotainment system
can only be switched on with the
e switch and with the j button for
the CD changer and off with the e
button.
■ If the Infotainment system is
switched off when the ignition is
switched off, regardless of the
current setting of the automatic
switch-on it, can only be switched
on via the e button and with the
j button for the CD changer.
■ The automatic start is always
enabled after the Infotainment
system has been disconnected
from the operating voltage and re-
connected.
Enable/Disable Ignition Logic
In the main menu press SETTINGS
button.
The system Settings menu is
displayed.
Enable/disable Ignition logic tick box.