Enable SSH
Note: This feature may be enabled using the default settings without the need
for configuration.
1. Open the SSH form, Configure > Services > SSH > SSH (form).
2. Complete the SSH form (if this is the first time Unauthenticated SSH has been used), a
description of the input data is provided at Properties and Settings in this topic.
3. When required, enable the Unauthenticated SSH feature by clicking the Enabled but-
ton.
Note: Unauthenticated access to all serial ports will be available through
SSH on TCP port 3000+ or Serial Port IP aliases.
Enable/Disable
Enabling or disabling this feature is done in the user interface.
To enable the feature click on the Enabled button then click the Apply button. The
feature is enabled immediately and a pop-up will confirm that the feature is
enabled.
Note: Clicking the Apply button saves any changes you have made to the
SSH form. A Details Saved banner confirms that the changes have been
saved.
To disable the feature click on the Disabled button then click the Apply button.
There is no confirmation pop-up when the feature is disabled.
CONFIGURE MENU 123
To Next Page
Loading...
Need help?
General