1.
Navigate to Configure > SNMP Alerts > Power > Voltage.
2.
Click on the Alerting button to activate the function, this also activates the
user-defined range sliders.
Note: The Not Alerting button de-activates the function and power alerts
will be stopped until activated again
3.
Click+Drag the voltage range limiters to the required upper and lower limits.
4.
Click Apply. The Details Saved banner confirms your settings.
In the above image, if any power supply fails, is disconnected or some other power
anomaly occurs which causes the voltage to drop below 11V or above 13V, an
SNMP alert will be triggered.
Warning: The recommended safety settings are 11.4 ~ 12.6 volts.
When an event occurs that causes the voltage range on any power supply to re-
enter the configured voltage range, it will cause an SNMP alert to be triggered.
CONFIGURE MENU 59
To Next Page
Loading...
Need help?
General