To provision the ACU with a laptop:
1. Using a computer that is on the same network as the ACU, go to
https://control.openpath.com and log in
2. Go to Hardware > ACU Management
3. Locate your ACU on the list
4. If you don't see your ACU listed, create a new one:
a. Click Add ACU and enter a name
b. Click on the Controller Type dropdown, select the appropriate type, and
add any expansion boards if necessary
c. Click Save
5. On the ACU, press the ADMIN button
6. In the Control Center, click the Register button (lightning icon) next to the
name of your ACU
7. Click Yes to proceed
8. A new window will open, click Provision
9. If you see a "This Site Cannot be Reached" error, you need to ping the ACU
using the command line:
a. Open a command prompt and run:
i. On Windows: ping oppi.local
ii. On Mac or Linux: ping -c4 oppi.local
● If nothing returns, check your network requirements. See
NETWORK REQUIREMENTS.
b. You should see the ACU's IP address (either in IPv4 or IPv6 format). Copy
the address and return to the error page.
c. In the URL, delete everything before :8080
i. If using an IPv4 address, paste before :8080. For example:
192.0.2.0:8080
ii. If using an IPv6 address, delete the last two digits and the
percentage sign, put square brackets outside the address, and
paste before :8080.
● Correct: [a123::b456:5a18:eb8f:7fd6]:8080
● Incorrect: a123::b456:5a18:eb8f:7fd6%29:8080
iii. Hit Enter, then click the Provision button
iv. If the Provision button still doesn't appear, contact Openpath
Support at (844) 673-6728 Ext 2 or support@openpath.com.
NETWORK SETTINGS
In the Open Admin app, you can configure network settings for the ACU.
To change network settings:
To Next Page
Loading...
