154 Statistics
Sure Sort™ Operator Manual
OPEX Corporation
Optical Over-height
Sensor Blocked
The Optical Over-height sensor is located on the input
section of the machine, and detects whether a piece
going down the conveyor exceeds the maximum
height limit of the system. If the sensor is blocked
upon startup of the system, a jam will be triggered.
Rear Safety
Controller not Reset
The system has a safety interlock that will not allow
the system to run if the reset button attached to the
rear stacker door of the system is not pressed. The
reset button must be pressed each time the door is
opened from a safe state. The reset button will not be
active until the door is closed.
Return Conveyor E-
Stop Pressed
Occurs if the Emergency Stop (E-Stop) switch on the
motorized return conveyor has been pressed.
Safety Controller
not Ready
The system has a safety interlock that will not allow
the system to run if the controller is not in a ready
state. All safety features, including emergency stops
and door interlocks, must be reset in order to run the
system.
Software Error or
Software Problems
Detected
Occurs when an unexpected situation arises in the
software.
Stacker Door is
Open
The system has a safety interlock that will not allow
the system to run if either of the stacker doors of the
system are open. The door does not have to be
completely open in order for this stoppage to occur. If
the interlock is broken, even briefly, the system will
stop and require a reset once all interlocks have been
satisfied.
Stacker Rear Door is
Open
The system has a safety interlock that will not allow
the system to run if the stacker door at the rear end of
the system is open.
Stacker Section 100-
Side E-Stop Pressed
Occurs if one of the Emergency Stop (E-Stop)
switches on the 100 side of the machine have been
pressed.
Jam message Description
To Next Page
Loading...
