User’s ManualUser’s Manual
Optex Inc. - 1845 W 205th St. - Torrance, Ca. 90501 - 800-966-7839 SMDC-16 User’s Manual 3440-0250 A3
10 of 16
About Your Alarm System
Walk Test
• If a zone(s) name is not removed from the keypad
display at the completion of the test, re-activate the
device(s). If it still is not removed from the display
contact your alarm company.
• NOTE: It is strongly recommended that this Walk
Test function be performed once a month to ensure
proper operation of your security system.
Operation:
1. Press WALK.
2. Enter PIN.
3. The keypad will be scrolling all protection devices.
4. Test all protection devices.
5. At completion of test observe “Walk Test Done”.
6. Press CLEAR.
Example:
press - WALK + Œ•Ž• + test devices -observe “Walk
Test Done”- press CLEAR.
Sensor Reset
Description:
• This procedure will allow your security system to reset
the light (or LED) on each of the smoke detectors that
activated an alarm condition.
Operation:
1. Press RESET.
2. Enter your Pin.
3. Keypad will display RESETTING SW AUX
(monetarily).
Example:
press RESET + Œ•Ž• + observe message
“RESETTING SW AUX”.
Note: This command must be performed after an
smoke detector alarm activation to allow you to arm
your security system.
WARNING:
• It may be imperative to your installing company for
you to note which of the smoke detectors activated an
alarm condition before performing a RESET
command. This will assist your installing company in
determining if there was a problem on your fire circuit
and which detector might have created the problem.
About Your Alarm System
Scanning Troubles
Description:
• Your alarm system is continuously performing a self
diagnostics check to ensure proper operation of the
following:
1. AC Failure.
2. Low Battery.
3. Telephone Failure.
Note: Should any of these failures display at your keypad,
immediately contact your alarm company.
Operation:.
Observe and note failure message.
1. Keypad will be emitting alert tone and display message.
2. Enter your PIN.
3. Tone will silence.
4. Call alarm company for service.
Example:
Observe and note trouble message - press Œ•Ž• -
tone will silence.
To Next Page
