User’s ManualUser’s Manual
Optex Inc. - 1845 W 205th St. - Torrance, Ca. 90501 - 800-966-7839 SMDC-16 User’s Manual 3440-0250 A3
13 of 16
Programming (continued)
4. Extend Close Time
Description:Description:
• When the time arrives for your security system to
perform the Auto Arm function, you may extend the
time in 10 minute increments.
Operation:
1. Press PROGRAM and enter your PIN.
2. Press 4 (Extend Close).
3. Keypad will display 00 x 10 min.
4. Enter 2 digit value (your entry will be pulsate).
5. Press ENTER and then CLEAR.
6. Press CLEAR repeatedly to return to normal operating
mode.
5. Duress PIN
DescriptionDescription
• Duress PIN is a disarming code that may be used to
alert your central station that an individual is forcing
you to disarm your alarm system.
• No programming allowed unless this option has been
enabled by your alarm company.
• Contact your installing company for information
regarding the operation of this function.
Operation:
Contact your alarm company.
6. Auto Monitor
Description:Description:
• This option allows for your alarm system to
automatically be placed in an local alert mode.
• This option will not function should there have been
an activation of your alarm system during the previous
armed mode. Automatic, no command required.
Programming (continued)
7.1 Holiday Tomorrow:
Description:Description:
• Program this option if tomorrow will be a holiday.
• Consult your alarm company if this option will be
enabled.
Operation:
1. Press PROGRAM and enter your PIN.
2. Press 7 (Select Holiday).
3. Press 1 (Holiday Tomorrow).
4. Press 0 if NO - 1 if YES.
5. Press ENTER and then CLEAR.
6. Press clear repeatedly to return to normal operation.
7.2 Holiday is next Monday:
Description:Description:
• Program this option if the following Monday will be a
holiday and the premises will not be disarmed.
• Consult your alarm company if this option will be
enabled.
Operation:
1. Press PROGRAM and enter your PIN.
2. Press 7 (Select Holiday).
3. Press 1 (Holiday Tomorrow).
4. Press 0 if NO - 1 if YES.
5. Press ENTER and press CLEAR.
6. Press clear repeatedly to return to normal operation.
PIN Levels
Arming & Programming Functions Level 1 PIN Level 2 PIN Level 3 PIN Level 4 PIN Level 5 PIN
Arm System
l l l l l
Disarm
l l l l
Bypass Zones
l l l
Detector Reset l l l l
Force Arm l l
PIN Programming
l l
Scan Zone Status l l l l l
User Programming l l l
System Features Level 1 PIN Level 2 PIN Level 3 PIN Level 4 PIN Level 5 PIN
Change Clock Settings
l l l
Change Schedules l
Enter/Exit Monitor Mode
l l l l
Enter/Exit Walk Test Mode
l l l l
Extend Closing Time l l
View History Buffers
l l l l
To Next Page
Loading...
Need help?
General