Opticon ESL
ESL Server manual
v1.0.62.2
24
discovered and configured on the default IP-address: 169.254.19.63 using the configuration
webpage.
Do not use a WiFi connection to connect your ESL server to the EBS-3x/4x’s to unsure a
reliable connection.
The default password of the configuration page is ‘admin’.
The base station can also be controlled over the Internet or via a public network, but it won’t
be a secure solution, since SSL isn’t supported yet in this SDK nor is the webpage
password protected.
5.5. Factory default
To set the base station back to factory default, apply power with the reset button pressed and
keep it pressed for 15 seconds. This will re-enable DHCP and set the IP address and subnet
mask back to the default values: 169.254.19.63 / 255.255.0.0. Also the other configurations will
reset to factory default.
Important: If DHCP is disabled and the current IP address and subnet mask are unknown, then
it’s possible to recover the EBS-3x by applying power the device with the reset-key pressed. This
will re-enable DHCP temporarily to allow reconfiguration of the base station on a network with
DHCP enabled.
To Next Page
Loading...
Need help?
General
