Safety
Version 1.0.3 - 2022-04-06 12 Translation of original instruction
D17 Pro│D23 Pro│D26 Pro│D33 Pro
EN
D17Pro_D23Pro_D26Pro_D33Pro_GB_1.fm
a drill chuck guard, in order to prevent interference with the rotating tool.
a switch in the protective cover of the V-belt.
INFORMATION
The drilling machine can only be switched on if the drill chuck guard is closed.
WARNING!
Although the isolating safety devices provided and delivered with the machine are
designed to reduce the risks of workpieces being ejected or parts of tools or workpieces
breaking off, they cannot eliminate these risks completely. Always work carefully and
observe the limits of the machining process.
1.10 Safety check
Check the drilling machine before each start-up or at least once per shift. Inform the person
responsible immediately of any damage, defects or changes in the operating function.
Check all safety devices
at the beginning of each shift (with the machine stopped),
once a week (with the machine in operation) and
after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the drilling machine
are legible (clean them, if necessary)
are complete (replace if necessary).
INFORMATION
Organise the checks according to the following table;
General check
Equipment Check OK
Guards Mounted, firmly bolted and not damaged
Signs,
Markers
Installed and legible
Date: Checked by (signature):
Functional check
Equipment Check OK
Emergency stop button After the emergency stop button is pressed, the drilling
machine must switch off.
Drill chuck guard The drilling machine may only switch on, if the drill chuck
guard is closed. The engine must switch off when the drill
chuck guard is opened during operation.
Protective cover of V-
belt.
The drilling machine may only switch on, if the protective
cover of V-belt is closed. The integrated switch must shut off
the motor when opening during operation.
Date: Checked by (signature):
To Next Page
Loading...
