Annex
Version 1.1.4 - 2022-09-2328 Originalbetriebsanleitung
GH 10T | GH 15T
EN
GH10T_GH15T_GB_6.fm
7Annex
7.1 Copyright
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
7.2 Terminology/Glossary
7.3 Change information manual
Term Explanation
Protective hood Cover of the grinding disc and of the drive shaft.
Protective cover Protective hood
Spark protection Cover to protect against sparks when grinding.
Point angle Angle of the complete tip of the drill bit
Clearance angle Relief grinding on the drill bit
Relief angle Clearance angle on the drill bit
Dead centre Tip of the drill bit
Prism Tool holder
Cutting edge Cutting line of the drill bit
Chapter Short note new version no.
4 Adjusting to reduce the chisel edge 1.0.1
2
Speed GH15T and GH10T after measurement 5000min
-1
Changed wheel max. grinding speed
parts drawing GH15T added
1.0.2
4.2.2 Expanded description, set drills 1.0.3
4.3.1 Expanded description, reduction of chisel edge 1.0.3
Spare parts GH10T updated layout as GH15T 1.0.4
New Possible malfunctions 1.0.5
4.3.1 Setting the reduction of the chisel edge 1.0.6
CE EMC 2014/30/EU 1.0.7
parts SDC grinding wheel as optional spare part 1.0.8
4 Using the different grinding wheels + drill geometry 1.0.9
CE
CE update,
2015/863/EU
1.1.0
Spare parts Additional spare parts drawing for GH10T 1.1.1
5 ; 6.2 Malfunction due to insufficient cleaning 1.1.2
To Next Page
Loading...
Need help?
General
