Optium Xceed User Manual

Control
Solution Testing
Control
Solution Testing
•LOT number (glucose) or
calibration CODE (ß-Ketone)
for the box of electrodes you
are using.
•Apply Blood message, which
tells you that the monitor is
ready for you to apply control
solution to the electrode.
Note: If you are a doing a
ß-Ketone control solution test,
KETONE will show on the
monitor’s display window
with the ß-Ketone Apply
Blood message.
5
To mark the test as a control
test, Press and Release the
button once. shows
on the display window.
Important: If you do not mark
the test as a control test, it will be
saved in your monitor’s memory
as one of your personal blood
glucose or blood ß-Ketone results.
This could affect your blood
glucose averages.
60
133-221 Manual,G3b,Aus 3/17/05 11:15 AM Page 63

Optium Xceed Specifications

General

Sample Size	0.6 microliters
Test Time	5 seconds
Battery Life	Approximately 1000 tests
Blood Sample	Capillary whole blood
Memory Capacity	450 results
Operating Temperature	10°C to 40°C
Operating Humidity	10% to 90% RH
Power Source	2 x AAA batteries