Using the Control Panel
Power
Refer to the “Power On/Off the Projector” section on
pages 13-14.
RE-SYNC
Automatically synchronize the projector to the input
source.
Enter
Con rm your item selection.
SOURCE
Press “SOURCE” to select an input signal.
Menu
Press “Menu” to launch the on-screen display (OSD)
menu. To exit OSD, Press “Menu” again.
AV MUTE
Momentarily turns off/on the audio and video.
Four Directional
Select Keys
Use to select items or make adjustments
to your selection.
Keystone
Use to adjust image distortion caused by
tilting the projector. (±40 degrees)
Lamp LED Indicate the projector’s lamp status.
Temp LED Indicate the projector’s temperature status.
ON/STANDBY LED Indicate the projector’s status.
To Next Page
Loading...
