EasyManuals Logo

Optoma UHD51 User Manual

Optoma UHD51
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
English
7
FCC
This device has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This device generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this device does cause
harmful interference to radio or television reception, which can be determined by turning the device off and on is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the device and receiver.
Connect the device into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/television technician for help.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain compliance with FCC
regulations.
Caution
Changes or modications not expressly approved by the manufacturer could void the user's authority, which is
granted by the Federal Communications Commission, to operate this projector.
Operation Conditions
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received, including interference that may cause undesired operation.
Notice: Canadian users
This Class B digital apparatus complies with Canadian ICES-003.
Remarque à l'intention des utilisateurs canadiens
Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.
Declaration of Conformity for EU countries
EMC Directive 2014/30/EC (including amendments)
Low Voltage Directive 2014/35/EC
R & TTE Directive 1999/5/EC (if product has RF function)
WEEE
Disposal instructions
Do not throw this electronic device into the trash when discarding. To minimize pollution and ensure
utmost protection of the global environment, please recycle it.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Optoma UHD51 and is the answer not in the manual?

Optoma UHD51 Specifications

General IconGeneral
Native aspect ratio16:9
Projection distance1.2 - 8.1 m
Vertical scan range24 - 120 Hz
Horizontal scan range31 - 135 kHz
Projection technologyDLP
Supported aspect ratios4:3, 16:9
Contrast ratio (dynamic)500000:1
Contrast ratio (typical)-
Screen size compatibility34.1 - 302.4 \
Projector native resolution2160p (3840x2160)
Lamp power240 W
Lamps quantity1 lamp(s)
Light source typeLamp
Service life of light source4000 h
Service life of light source (economic mode)10000 h
Offset105 %
Throw ratio1.21 - 1.59:1
Zoom capabilityYes
Focal length range12.81 - 16.74 mm
Vertical lens shift range-10 - 10 %
DVI portNo
HDMI connector typeFull-size
Serial interface typeRS-232
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in0
Noise level25 dB
On Screen Display (OSD) languagesCHI (SIMPL), DEU, ENG, ESP, FRE, ITA, JPN, POR, RUS
Supported video modes480i, 480p, 576i, 576p, 720p, 1080i, 1080p, 2160p
Supported graphics resolutions640 x 480 (VGA), 800 x 600 (SVGA), 1024 x 768 (XGA), 1280 x 1024 (SXGA), 1280 x 720 (HD 720), 1280 x 768 (WXGA), 1600 x 1200 (UXGA), 1920 x 1080 (HD 1080), 1920 x 1200 (WUXGA), 3840 x 2160
PlacementDesktop
Product typeStandard throw projector
Product colorBlack
Market positioningHome cinema
Cable lock slot typeKensington
Cables includedAC
RMS rated power10 W
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (max)305 W
Power consumption (standby)0.5 W
Operating altitude0 - 3000 m
Operating temperature (T-T)5 - 40 °C
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth281 mm
Width392 mm
Height118 mm
Weight5220 g

Related product manuals