Remove Faulty DIMMs
Remove Faulty DIMMs
Note - Information in this appendix does NOT apply to Oracle Database Appliance X3-
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing DIMMs from Oracle Database Appliance Version 1.
Note - The DDR3 memory modules (DIMMs) are customer-replaceable units (CRUs) and do
not require an Oracle-qualified service person for replacement.
1.
Prepare the server node for service.
a.
Attach an antistatic wrist strap.
See “Performing Electrostatic Discharge and Antistatic Prevention
Measures” on page 146.
b.
Remove the server node from the system.
Power is removed from the server node when you remove it from the system. See
“Removing Server Nodes From the System Chassis” on page 147.
c.
Remove the server node top cover.
See “Removing the Server Node Top Cover” on page 149.
2.
Identify the faulty DIMM(s).
a.
To identify the location of a faulty DIMMs, press the Fault Remind button on
the motherboard.
170 Oracle Database Appliance Service Manual • November 2017
To Next Page
Loading...
Need help?
General