Oracle Solaris Cluster 3.3 - Installing and Maintaining a SCSI RAID Storage Device; Restrictions and Requirements

Installing and Maintaining a SCSI RAID Storage
Device
This chapter describes the procedures about how to install, congure, and maintain SCSI RAID
storage devices that use Sun StorEdge RAID Manager software in an Oracle Solaris Cluster
environment.
The procedures in this chapter apply to the following SCSI RAID storage devices:
■
Oracle's Netra st A1000 array
■
Oracle's Sun StorEdge A1000 array
■
Oracle's Sun StorEdge A3500 system
This chapter contains the following sections:
■
“Restrictions and Requirements” on page 11
■
“Installing Storage Arrays” on page 12
■
“Conguring Storage Arrays” on page 22
■
“Maintaining Storage Arrays” on page 31
Restrictions and Requirements
This section includes only restrictions and support information that have a direct impact on the
procedures in this chapter. For general support information, contact your Oracle service
provider.
■
RAID Manager software 6.22.1 or later version is required.
■
(StorEdge A3500 Only) Do not use LUNs as quorum devices.
1
CHAPTER 1
11