Oracle Solaris Cluster 3.3 User Manual

TABLE 1–3 Task Map: Maintaining a Storage Array or Storage System (Continued)
Task Information
Upgrade controller module rmware and NVSRAM le “How to Upgrade Controller Module
Firmware” on page 39
Add a disk drive “How to Add a Disk Drive” on page 40
Replace a disk drive “How to Replace a Disk Drive” on page 41
Remove a disk drive “How to Remove a Disk Drive” on page 43
Upgrade disk drive rmware “How to Upgrade Disk Drive Firmware” on
page 44
Replace a host adapter “How to Replace a Host Adapter” on
page 44
FRUsThat Do Not Require Oracle Solaris Cluster
Maintenance Procedures
Each storage device has a dierent set of FRUs that do not require cluster-specic procedures.
Choose among the following storage devices:
■
Netra st A1000 array
■
Sun StorEdge A1000 array
■
Sun StorEdge A3500 system
Sun StorEdge A1000 Array and Netra st A1000 Array FRUs
The following is a list of administrative tasks that require no cluster-specic procedures. See the
Sun StorEdge A1000 and D1000 Installation, Operations, and Service Manual and the Netra st
A1000/D1000 Installation and Maintenance Manual for these procedures.
■
Replacing a power supply
■
Replacing a battery unit
■
Replacing a storage array cooling canister
■
Replacing a power cable on the storage array
Replacing a storage array-to-host SCSI cable requires no cluster-specic procedures. See the
Sun StorEdge RAID Manager User’s Guide and the Sun StorEdge RAID Manager Release Notes
for these procedures.
Maintaining Storage Arrays
Oracle Solaris Cluster 3.3 With StorEdge A1000 Array, Netra st A1000 Array, or StorEdge A3500 System Manual
• May 2011, Revision A
32

Oracle Solaris Cluster 3.3 Specifications

General

Brand	Oracle
Model	Solaris Cluster 3.3
Category	Server
Language	English