Orava Dehum 1 - Assembly and Operation; Before First Use; Installation

15
EN
Assembly and operation
Before fi rst use
• Unpack the device and remove all packaging material and any protective fi lm.
If the wheels are not mounted, mount them on the bottom of the device.
INSTALLATION
Location
• Place the device on a solid and level surface in an area with at least 30 cm of
free space around the device to ensure proper air circulation.
• Never install the device where it could be exposed to heat sources such as
radiators, heat exchangers, stoves or other heat-generating products.
• Never install the device in an area where it may be splashed with oil or water,
exposed to direct sunlight, mechanical vibration or shock, excessive dust,
insuffi cient ventilation, such as in cabinets or bookcases, on uneven and
unstable surfaces.
WARNING!
Only install the device in rooms with a fl oor area of more than 4 m².
Do not install the device in places where fl ammable gases could escape.
NOTE
The refrigerant manufacturer can provide further information on the possible odor
of the refrigerant.
SAFE OPERATION OF THE DEVICE
• After unpacking, check the device for damage
or scratches.
• Use this device in an ambient temperature of
5 °C to 35 °C.
Do not use it outdoors. This dehumidifi er is
intended for indoor use only.
• Do not operate the device in close proximity to
walls, curtains, or other objects that may block
the air intake and exhaust vents.
• Keep air intake and exhaust vents
unobstructed and unobstructed.
• Before starting, set the airfl ow defl ector
upwards.