Orava Dehum 1 - Maintenance and Cleaning

17
EN
SLEEP/RESET button
When you press SLEEP/RESET, the indicator lights up and sleep mode is
activated, which means that the unit turns off automatically after a certain period
of time. Press and hold this button to reset the fi lter counter after replacing it.
TIMER button
Press the TIMER button to set the timer function from 1 to 24 hours. Each time
you press this button, the setting value increases by 1 hour, the set value is shown
on the display.
When setting the timer on, the time after which the device will turn off
automatically is set.
When setting the timer in standby mode, the time after which the device turns on
automatically is set.
Setting the time to „00“ cancels the timer function.
SPEED button (fan speed)
Press this button to toggle the fan speed between high
and low. The corresponding indicator always lights up. In continuous drying mode,
it is not possible to change the fan speed during sleep mode and defrost time.
ION/LOCK button
Press and hold this button to activate or deactivate the child lock function. When
the child lock function is activated, all controls are locked and the device cannot
be operated with them. Press this button to activate or deactivate ionization
function. The ionization function enriches the air with benefi cial negative ions,
eliminates dust and cleans the air in the room.
Humidity indicator - humidity indication
The humidity in the room is indicated by colored lights: red: humidity more than
65%, green: humidity 45%-65%, blue: humidity less than 45%.
Maintenance and cleaning
CONDENSATE DRAINAGE (DETERMINED WATER COLLECTION)
There are two ways to remove water trapped by the dehumidifi er.
Manual removal:
Manually remove the water tank and pour it out.
Continuous condensate drain:
Drainage of condensate by means of a drain hose into the sewer by gravity.