Orava Dehum 1 - Settings and Operation

To Next Page

To Previous Page

• If the device has been tilted by more than 45 ° before operation, leave it in an

upright position for at least 24 hours before commissioning.

• Keep doors and windows closed for greater energy savings.

• Do not operate or store the device in direct sunlight or rain.

• It is normal for the air vents to be hot to the touch after continuous operation

on hot days.

• Empty the water tank before moving the device.

• Make sure that the water tank is installed correctly, otherwise the unit will not

work properly.

• The dehumidiﬁ er starts in the mode selected when the device was last used.

• The dehumidiﬁ er starts dehumidifying if the humidity in the room is 3% higher

than the set humidity.

• The compressor has a protective 3-minute time delay. Wait 3 minutes for the

dehumidiﬁ er to resume dehumidiﬁ cation.

Power supply

The device operates on AC voltage 230 V, 50 Hz from the mains.

Before using the device, it is necessary to connect the appliance to the mains

using a mains cord to a wall socket with the prescribed voltage.

SETTINGS AND OPERATION

Place the device in the desired location in the room and set its operation using the

controls on the control panel.

Switch on the device using the STAND-BY button and use the other buttons to

select its operating mode, fan speed, timer, etc.

STAND-BY button 1

In standby mode, press to turn on the device.

The operation indicator lights up and the device starts operating. The fan speed is

high.

In the on state, press this knob to turn off the device.

The operation indicator goes out and the compressor stops immediately. After a

30-second delay, the fan also stops running.

MODE button

Press the MODE button to switch between automatic mode and drying mode (e.g.

laundry).

Automatic mode (AUTO):

In this mode, it is possible to set the humidity and fan speed.

Drying mode (DRY):

In this mode, the compressor operates continuously without the possibility of

humidity control. The fan runs at high speed (neither the fan speed nor the

humidity can be adjusted).