18
EN
MANUALLY EMPTYING THE WATER TANK
After fi lling the inserted water tank, the device stops.
Remove the tank and pour out the water. After re-inserting the tank correctly into
the device, it will be possible to restart the device.
Proceeding:
• When the tank is full, a buzzing sound sounds from the device and a message
lights up „Water Full“.
• Press STAND-BY to turn off the unit.
• Remove the water tank by simply sliding it out of the dehumidifi er body.
• Pour out water e.g. to the sink.
• Clean the inside of the tank and the outside.
• Properly insert the empty tank back into the device.
• Press the STAND-BY button to resume operation of the unit.
If operation does not start and the „Water Full“ indicator does not go out, check
that the fl oat is in place.
CONTINUOUS DRAINAGE OF CONDENSATE
Connect the supplied drain hose to the device for continuous operation or
unattended dehumidifi cation. The condensate (trapped water) can then drain
spontaneously into the sewer or into a designated container.
• Place the device on a horizontal surface in a stable position.
• Switch off the device before connecting the drain.
• Pull out the plug of the water outlet and store it in a safe place.
• Connect the drain hose securely and correctly to the water outlet and make
sure that it is not kinked or blocked.
• Place the outlet end of the hose in the sewer, sink, etc.
and ensure that the hose drops continuously so that water can drain freely by
gravity from the device.
• Do not immerse the end of the hose in water,
otherwise it may cause an „air chamber“
to form in the hose and prevent water from
fl owing.
Drain hose
To Next Page
Loading...