1.14 ERROR MESSAGE
Please unplug and plug in the power cord
again.
1. Please try restart the treadmill and
lubricate the running board first.
2. Check if motor has burned smell. If so,
change a motor.
3. Check if lower control board has
burned smell. If so, change a new
1. Make sure the wire is connected well
on the motor.
2. Change a new motor.
3. Change a new controller.
1. Please try restart the treadmill first.
2. Check if the power plug is well
connected to treadmill.
3. Change a new controller.
1. Make sure the wire is connected well
on the motor.
2. Change a new motor.
3. Change a new controller.
1. Check if the input voltage is normal.
2. Check if the power plug is well
Check if the input voltage is normal.
1. Check if the power plug is well
connected to treadmill.
2. Change a new controller.
1. Turn off the machine for over 2
minutes and then restart.
2. If the console is still inactive, change a
Please wait until the temperature is back to
normal
Please check if UVW wire is connected well.
Please contact your dealer about this issue.
1. Check if console wire and controller
are connected well.
2. Check if the controller is broken.
25
To Next Page
Loading...
