Orbitsound T12 - Enhancement to TV Sound (replacing TV speakers); iPod Control & Charge; Charge; Menu

12
Battery replacement (remote)
Replace remote battery with anode up (+) from back-side.
BATTERY: CR 2025
Troubleshooting
No sound is heard
• Check power connections and that there is a continuous blue light on the front
of the unit.
• Check that the iPod/TV or other sound source is playing and that it is connected
properly to the soundbar. With iPod, check that the unit is docked fully. If
unsure that your media device is playing, unplug, and test with headphones.
• Press the sound source button on the remote (or briey press volume knob on
rear of soundbar) to change the sound source. The blue light ashes briey
when the sound source is changed.
• Adjust the volume of the soundbar until sound is heard and press source button
again if there is still no sound.
The sound is out of sync with the TV
• Make sure all video sources are connected to the TV and that the soundbar is
connected to the TV optical sound output or RCA sound output sockets. This
connection method should re-align the sound. If it is still out of sync, look for a
sound/time alignment menu in the TV menus.
Remote does not work
• Check that plastic strip in remote (if there is one) has been removed
• If the remote has had a lot of use, replace the battery.
• Check there are no obstructions between the remote and the front of the
soundbar.