Orbitsound T12 - Basic Operation; Power On; Source Selection

7
Basic operation
1. Power on
Power on Standby
or
Press & hold
IMPORTANT: The main power switch must be on for T12 operation. This is
located on the rear of the soundbar unit.
Standby / On: The T12 may be put into ‘standby’ or switched on by pressing the
PWR button on the remote. Briey pressing the volume control on the rear of the
soundbar also switches on the unit. Pressing and holding the volume button for 2
seconds will enable standby mode.
NOTE: The colour of the LED on the front of the T12 shows the current status of the unit.
Red means the unit is in standby mode. Solid blue indicates that the unit is on.
2. Source selection
iPod Dock AUX Digital Coax Optical
or
(PUSH)
or
(PUSH)
or
(PUSH)
or
(PUSH)
(when iPod connected)
Source select: Press the ‘Source’ button on the remote (or briey press the volume
knob on the unit’s rear) to switch the sound source from iPod dock to Line/AUX
inputs to Digital Coax to Digital optical. The iPod selection is skipped if no iPod is
present (i.e. only 3 inputs when no iPod is in use).