Orca 40 CL - Page 150

150
UTILISATION
150
INSTALLATION
PREVENTIVNÍ OPATŘENÍ
PŘI VKLÁDÁNÍ VYSAVAČE DO BAZÉNU JE TŘEBA Z NĚJ VYPUSTIT VZDUCH. TO SE
PROVEDE NÁSLEDOVNĚ:
VYSAVAČ JE TŘEBA DO BAZÉNU UMÍSŤOVAT A VYTAHOVAT HO Z NĚJ SPODNÍ
STRANOU OTOČENOU KE ZDI, ABY SE ZAMEZILO PŘÍPADNÉMU POŠKRÁBÁNÍ BAZÉNU.
1. Uchopte vysavač a ponořte jej svisle na 5-6 sekund do vody, dokud nepřestanou
vycházet bubliny (obr. 1).
2. Stisknutím vypínače vysavač zapněte a otočte jej o 90 stupňů.
3. Ponořte jej vodorovně na dno bazénu, dokud nebude z trysky vycházet velké množství
bublin (obr. 2).
POKYNY PRO POUŽITÍ
4
IV. Operating instruction
4.1. Precautions
a. When putting the cleaner into the pool, the air inside the cleaner should be discharged as follow:
① Hold the cleaner and submerge it vertically for 5-6 seconds until no bubbles come out (Fig. 1).
② Press the switch button to power on and rotate the cleaner 90 degrees.
③ Submerge it horizontally into the pool floor until a large number of bubbles are discharged from
the nozzle (Fig. 2).
Fig. 1 Fig. 2
b. Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any possible
scratches to the pool.
C. Please ensure that the top cover of the cleaner is tightly assembled to its chassis.
4
IV. Operating instruction
4.1. Precautions
a. When putting the cleaner into the pool, the air inside the cleaner should be discharged as follow:
① Hold the cleaner and submerge it vertically for 5-6 seconds until no bubbles come out (Fig. 1).
② Press the switch button to power on and rotate the cleaner 90 degrees.
③ Submerge it horizontally into the pool floor until a large number of bubbles are discharged from
the nozzle (Fig. 2).
Fig. 1 Fig. 2
b. Put into or lift out of the pool with the cleaner bottom towards the wall to avoid any possible
scratches to the pool.
C. Please ensure that the top cover of the cleaner is tightly assembled to its chassis.