Orca 40 CL - Page 151

151
UTILISATION
151
INSTALLATION
UJISTĚTE SE PROSÍM, ZDA JE HORNÍ KRYT VYSAVAČE PEVNĚ PŘIPEVNĚNÝ
K PODVOZKU.
PŘI NABÍJENÍ JE PŘÍSNĚ ZAKÁZÁNO PŘEVRACET VYSAVAČ DNEM VZHŮRU,
ABY NEDOŠLO K POŠKOZENÍ VÝKYVNÉ DESKY.
PŘI UPEVŇOVÁNÍ HORNÍHO KRYTU
K PODVOZKU DBEJTE NA SPRÁVNÝ SMĚR
INSTALACE, JAK JE ZNÁZORNĚNO NA NÍŽE
UVEDENÉM OBRÁZKU: POLOHA ŠIPKY
U SPONY HORNÍHO KRYTU MUSÍ BÝT
V JEDNÉ LINII S OTVOREM V BLÍZKOSTI
SPONY PODVOZKU.
POKYNY PRO POUŽITÍ
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.
5
dd. When fastening the top cover and chassis, please focus more on the installation direction as
shown in the below figure: the arrow position near the buckle of top cover should be aligned with
the hole position near the buckle of chassis.
e. When charging, it is strictly forbidden to face the bottom up to prevent the swing plate from
being crushed.