Tires (Figure 11)
Check tires are not cutted, cracked or worn.
Check tires pressure : 1,4 bar rear.
SAFETY STICKERS
•Check safety stickers are sticked at their place. Replace them if
they are worn and damage.
AIR FILTER
-Open the air cleaner cover and remove the dual-filter elements.
-Remove the foam filter element from the paper filter element.
-Clean paper filter element with compressed air (read the engine
manual).
-Clean foam filter element with soapy water, and dip in oil(read the
engine manual).
-Install the elements and air cleaner cover referring the engine
manual.
ENGINE OIL LEVEL :
Refer to engine manual. With the engine cold or stopped at
least since 10 minutes on a plate level place. Check level with the
oil filter cap (1, Figure 13). Unscrew the plug, wipe it and install
without screwing it. Check the level that must be between the two
marks.
Engine oil : SAE 10W30 or API SL class
Engine oil quantity : 0.6L(HR531), 1.1L (HR662/672/812)
Remove oil drain plug(2, Figure13) in case of changing oil.
Engine oil replacement
First : 20 hours
Later : each 100 hours or every year whichever comes first.
BLADE AND BLADE HOLDER CONDITION
CAUTION
You can be cutted and injuried by cutting flails. Always
wear gloves when holding flails.
Check if flails are in good condition, change worn or damage
parts.
Changing flails : unscrew hexagonal bolt on the rotor.
Check the blade condition. Change it if it is worn, bend or
cracked.
To Next Page
Loading...
