Release the trigger and slowly push forward
over the sprayed area. Then slowly pull back
toward you without squeezing trigger (dry
stroke). Continue using dry strokes until little
water is visible.
15
For best cleaning results, end with more dry
strokes. (Continue using dry strokes until little
water is visible passing through the nozzle.)
For best results, Oreck
®
recommends rinsing
carpet with water only. This removes residual
carpet cleaning solution. Fill Clean Water
tank with water only. For heavily soiled areas,
repeat. Avoid saturating carpet.
NOTE: Empty Dirty Water Tank when the motor sound becomes higher pitched and there is a loss in suction (see “Automatic shut-off”).
NOTE: It is best to alternate wet and dry strokes as described below.
To rinse carpets, empty the Clean Water
Tank and fill with water only before going
over carpets again.
To Next Page
Loading...
Need help?
General
