3. OPERATION
USING YOUR MACHINE
Plug in. Step on the handle release
pedal to put unit in cleaning position.
Step on the power pedal to turn ON (I=ON).
Press the power pedal again to turn OFF
(0=OFF).
Squeeze trigger to apply cleaning solution.
Slowly push forward then backwards while
squeezing the trigger (wet stroke).
NOTE: For best results, use straight, parallel strokes. Overlap strokes by 1 in. to help prevent streaking.
DO NOT CLEAN OVER FLOOR ELECTRICAL OUTLETS. WATER WILL DRIP FROM THE BRUSHES AND UNDERSIDE OF THE PRODUCT AFTER USE AND MAY PUDDLE.
TO AVOID DAMAGE TO WOOD AND LAMINATE FLOORING AND TO AVOID POTENTIAL SLIP HAZARD, AFTER USE (A) DO NOT LEAVE THE PRODUCT ON WOOD AND
LAMINATE SURFACES AND MOVE TO A HARD SURFACE AND (B) PLACE UNIT ON AN ABSORBANT MATERIAL (SUCH AS A TOWEL) TO SOAK UP DRIPS.
CAUTION!
To Next Page
Loading...
Need help?
General
