5. TROUBLESHOOTING
If appliance is not working as it should, has been dropped, damaged, left outdoors or dropped into water, take it to a service center prior to
continuing use. Any other servicing should be done by an authorized service representative.
Cleaner won’t pick up
or has low suction
Water escapes
from Cleaner
ResolutionCause
• Plug unit in firmly.
• Check fuse or breaker in home.
• Replace fuse/reset breaker in home
• Power cord not firmly plugged into outlet.
• No voltage in wall plug.
• Blown fuse or tripped breaker.
• Review Emptying your Dirty Water Tank (Pg. 14)
• Empty Dirty Water Tank.
• Clean Dirty Water Tank.
• Unclog air path/nozzle.
• Empty Dirty Water Tank.
• Review Emptying your Dirty Water Tank (Pg. 14)
• Review Clean Water Solution Tank Installation.
• Dirty Water Tank is not installed correctly.
• Dirty Water Tank is full.
• Dirty Water Tank is clogged.
• Air path is clogged.
• Dirty Water Tank is full.
• Dirty Water tank is not installed correctly.
• Clean Water Solution Tank not installed properly.
Problem
Cleaner will not run
TO REDUCE THE RISK OF PERSONAL INJURY—UNPLUG BEFORE CLEANING OR SERVICING.
WARNING!
To Next Page
Loading...
Need help?
General
