Cleaner will
not dispense
• Fill Clean Water Solution Tank.
• Review Clean Water Solution Tank Installation.
• Take to service center. To find nearest location, visit our website at
www.oreck.com or call 1.800.989.3535.
• Clean Water Solution Tank is empty.
• Clean Water Solution Tank not installed properly.
• Needs service.
31
Problem
Motor noise becomes
high-pitched
Brushrolls are
not spinning
ResolutionCause
• Turn on the cleaner. If hose does not spray, prime the pump by lowering
the hose down to the floor and hold the trigger for up to 1 minute.
• Ensure that the Hose is securely connected to the hose connection.
• Air is trapped in the pump and hose.
• The connection to the tool port is loose.
• Empty Dirty Water Tank.
• Clean Dirty Water Tank.
• Unclog air path.
• Review Emptying
& Cleaning the Dirty Water Tank.
• Refer to how to change belt.
• Remove jammed item from cleaner with unit turned off and unplugged.
• Dirty Water Tank is full.
• Dirty Water Tank is clogged.
• Air path is clogged.
• The float in the Dirty Water Tank has been activated.
• Belt needs to be changed.
• Something is jammed in the brushroll.
• Needs service.
Hose nozzle will not
spray after filling the
Clean Water Tank or
Detergent Container
To Next Page
Loading...
Need help?
General
