Figure 6. Battery Compartment (Monitor)
1. Hi / Lo button
2. °C / °F button
3. reset button
Figure 7. Belt Clip and Stand Position
SETUP
INSTALLING THE BATTERIES
Follow these steps to install the batteries.
In the Monitor (Figures 3,5 and 7)
1. Slide down and lift the belt clip off the back of the monitor.
Slide then lift up to remove the battery compartment
cover.
2. Place two AA batteries in the compartment as indicated by
the polarity symbols (+ and -).
3. Press
reset in the battery compartment using a pointed
object such as a paper clip (Figure 5).
NOTE Reset both the monitor and the thermometer sen
sor
within 60 seconds to synchronize signal transmission.
4. Replace the cover and the belt clip.
In the Thermometer Sensor (Figure 4)
1. Slide the battery compartment cover open.
2. Insert two AAA size batteries into the compartment
matching the polarities (as shown). Press
reset using a
pointed object such as a paper clip.
3. Replace the battery compartment cover.
NOTE When
appears on the monitor, replace the
batteries.
To Next Page
Loading...
