DS6688 Manual-Eng,Fre,Ger (086-003403-012)
EN
FR
DE
ITESPORNLSWE
EN
FR
DE
ITESPORNLSWE
1413
AUTO OFF (AUTO POWER-OFF)
You can set the camera to turn off automatically when no operation is
performed. The period of time before shut-down can be adjusted
(1 min., 3 min., or 5 min.) The default auto off time setting is 3 min.
NOTE: Auto Off is not available in slideshow mode or when the
camera is connected to a PC.
TV OUT
If connecting the camera to a TV, you can set the camera's TV output
system to either the PAL or NTSC standards. The default TV Out
setting is set to PAL.
FILE NUMBER
Your camera keeps an internal file counter for every image and movie
taken that can be reset. The setting options are Continue (default
setting) and New.
NOTE: All files are stored within a designated folder. The initial folder
is always numbered at 100.
A. Under the Continue default option, the internal file counter is first
set to "0001". Every subsequent picture is assigned an incremental
File Number.
NOTE: The internal file counter increments by 1 regardless of the
media unless it is reset.
B. Under the New option, the internal file counter to "0001" for new
media only. But in case there are image files already present inside
the storage media, it will start counting from the highest file number of
the media.
NOTE: The File Number setting should be set to New only if either the
internal memory or SD card has been newly formatted, or a completely
new SD card has been installed.
FORMAT
This option will format all data in either the internal memory or the
external SD card / MMC, including all protected files.
CAUTION: Do not eject the SD card / MMC while the card is being
formatted, as this may damage the card. Formatting deletes all data
from the memory device chosen. Files will not be recoverable.
RESET
You can reset all camera settings to factory default. Refer to the Setup
Menu table to see the defaults for each setting.
NOTE: The reset function can reset all the settings to factory default
except for the current time and date.
LCD BRIGHT (LCD BRIGHTNESS)
You can adjust the LCD brightness level to
compensate for different lighting conditions, for
example.
• If there is plenty of ambient light such as in
bright sunshine, you can adjust the brightness
levels higher to make the display easier to see.
• If ambient light levels are relatively low such as
indoors or at night, you can adjust the brightness
levels lower to make the display easier to see.
TIP: To maximize battery life, keep brightness settings low.
SYSTEM INFORMATION
This option allows you to check the camera model number and cur-
rent version of firmware installed.
To Next Page
Loading...
Need help?
General
