Oregon Scientific DS6688 - Addendum and Troubleshooting; Memory Capacity, Size, and Quality; Troubleshooting Common Problems

DS6688 Manual-Eng,Fre,Ger (086-003403-012)
EN
FR
DE
ITESPORNLSWE
EN
FR
DE
ITESPORNLSWE
2827
ADDENDUM
MEMORY CAPACITY, SIZE AND QUALITY
The table below indicates the number of images that can be stored
when using a 16MB Secure Digital / Multi-Media card.
Approximate Number of Pictures Stored
RESOLUTION under the Following Picture Quality Selections
HIGH STANDARD ECONOMY
Fine (2048 x 1536) 9 16 28
Normal (1280 x 1024) 29 40 56
Basic (640 x 480) 66 105 205
NOTE: The above table is based on standard shooting conditions
tested by Oregon Scientific and may vary depending on the subject,
shooting conditions, capture modes, and SD card memory capacity.
TROUBLESHOOTING
No Power
Taking
Pictures
Power will not
turn on
Power turns off
after turning on.
Cannot take
pictures when
Shutter Release
Button is pressed
Batteries are
exhausted
Batteries are
inserted incorrectly.
Battery level is
too low
Auto Off Function
is enabled.
Camera not
turned on
No space on the
SD card / MMC /
internal Memory.
Mode Switch is set
to Playback mode
Replace with new batteries
Insert the batteries
correctly
Replace with new batteries
Disable the Auto Off
Function
Turn on the camera.
Delete unwanted files or
insert a new SD card or
MMC
Change the Mode Switch to
Camera or Movie Mode
PROBLEM SYMPTOM CHECK THIS REMEDY
PROBLEM SYMPTOM CHECK THIS REMEDY
Playback
Connecting
with
External
Devices
Flash does not
go off as
expected.
Image taken
appears too dark
or blurred.
Cannot play
back images or
movies
Cannot delete
images or movies
Picture not
shown on TV
when connected
Camera does
not appear as
Removable Disk
when connected
to a PC
Flash is set to
No Flash Mode
Mode Switch is
set to Playback or
Movie Mode.
Flash has not
finished charging
Check your Flash
Mode
The subject is too
far away.
The lens is dirty
Incorrect focus
mode setting
Mode Switch is
not set to
Playback Mode
No images or
movies are
recorded
Images or movies
are protected
Check cable
connection
Check channel on
TV.
Check the USB
cable connection.
Camera or PC is
not turned on
Enable flash by changing it
to another setting
Change the Mode Switch to
Camera Mode.
Wait until the Status Lamp
stops blinking
Turn on the flash by
changing the Flash Mode
Move closer to the subject
Clean the lens with a soft cloth
Set the dial to the correct
focus distance
Set Mode Switch to
Playback Mode.
Images located in internal
memory instead. Remove
SD card / MMC
Unprotect the images or
movies
Make sure yellow video
cable is plugged into the
TV’s AV terminal
TV channel should be
switched to the
appropriate AV channel.
Turn on the camera and PC
Make sure both ends of the
USB cable are connected
All manuals and user guides at all-guides.com