EasyManuals Logo

Oricom TPS10 User Manual

Oricom TPS10
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
22
WARNINGS
1. (TPMS) is designed for vehicles with tyre pressure up to 6.0 Bar/ 86PSI.
2. All sensors in this unit have been pre-set individually for each tyre from
factory.
3. Whenever the location of a tyre is changed, the sensors must also be
changed to the corresponding tyre.
4. The display will turn off automatically after the vehicle stops and no
movement is detected for sometime.
5 Approval marks and numbers should not be removed from the product.
6. If the solar energy display is used in temperatures of higher than 80ºC (or
176ºF), the capacity of the built-in battery may be damaged.
7. If the display no longer holds a charge then it is time to replace the
display unit as the display unit battery is non-user replaceable.
8. Discharge and charge fully every 6 months to preserve battery life.
9. Store between -40ºC to +80ºC (-40ºF to +176ºF). Charge between -10ºC
to +65ºC (+14ºF to +149ºF).
10. Do not expose the display unit to high temperatures.
11. Do not disassemble or tamper with display unit and battery.
Driver Distraction warning
The driver should always operate a vehicle in a safe manner.
Minimising the amount of time spent viewing the display will prevent
distraction.
The display unit should be installed securely in a position that doesn't
obstruct the drivers view of the road.
Do not install the display unit in a position that may hinder the vehicles
operating controls.
Do not install in a location that will obstruct airbags.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oricom TPS10 and is the answer not in the manual?

Oricom TPS10 Specifications

General IconGeneral
BrandOricom
ModelTPS10
CategoryMeasuring Instruments
LanguageEnglish