Oricom TPS10 - Sensor Programming Mode; Enter Programming Mode; Initial Sensor Programming

17
Sensor programming
Sensor programming
Note: Sensors in 4 and 6 packs come programmed, Additional twin sensor
packs purchased will need to be programmed
When programming a new sensor or a missing sensor to the display.
Enter Programming Mode:
Press "
" button 5 times, the display will beep once to conrm you are
now in sensor programming mode.
Sensor Programming
Press the "
" button to cycle through the sensors.
- once the desired sensor position is ashing you are ready for programming
that sensor.
Psi
Psi Psi Psi
Trailer interface Spare interface
Interface