25
Operating using the operation panel
This chapter explains how to rotate the motor using only the operation panel without connecting an external control device.
Press
50 r/min (factory setting)
Press
The motor stops.
AC power ON
1
4
Turn
Changing speed of motor
[example: 50 to 1000 r/min]
The display blinks.
You can adjust the speed while blinking.
Press
Set
Adjustment
Press
5
Start of motor
The display changes to lighting from blinking,
and the speed will be set.
When you start the motor next time, it will rotate
at the set speed.
LOCAL
RUN
key
STOP
key
LOCAL
key
MODE key
Setting dial
LOCAL LED
Operation panel
Accelerate
Decelerate
To stop the motor
When the power supply is turned on,
the display shows as follows.
Display: Rotation speed
0 r/min (standstill)
The motor rotates.
Rotation direction selection
Press
∗
The gures show the round shaft type.
The motor rotation
direction changes
whenever the MODE key
is pressed.
The LOCAL LED
is lit in green.
The operation using the operation panel is set, and the
rotation speed and rotation direction are alternately
continued to show on the display.
Press the LOCAL key.
Press
3
Operation selection
2
Interval of approximately 1 second
Refer to p.32 for details about the operation panel.
Check the operating manual included with the motor for
the rotation direction of the gearhead output shaft.
To Next Page
Loading...
