Oriental motor BLH2D15-K - Maintenance and Inspection; Periodic Inspection Guidelines

18
Maintenance and inspection
8 Maintenance and inspection
8.1 Inspection
It is recommended that periodic inspections would be conducted for the items listed below after each operation of the
motor.
If an abnormal condition is noted, discontinue any use and contact your nearest Oriental Motor sales oce.
Note
•
Do not conduct the insulation resistance measurement or dielectric strength test with the motor and driver
connected.
Doing so may cause damage to the product.
•
The driver uses semiconductor elements, so be extremely careful when handling them.
Static electricity may damage the driver.

Inspection item
•
Check if any of the mounting screws of the motor and gearhead is loose.
•
Check if the bearing part (ball bearings) of the motor generates unusual noises.
•
Check if the bearing part (ball bearings) or gear meshing part of the gearhead generates unusual noises.
•
Check if the output shaft of the motor and gearhead and a load shaft are out of alignment.
•
Check if a damage or stress is applied on the cable or the connection part between the cable and driver is loose.
•
Check if dust is deposited on the driver.
8.2 Warranty
Check on the Oriental Motor Website for the product warranty.
8.3 Disposal
Dispose the product correctly in accordance with laws and regulations, or instructions of local governments.