Oriental motor US2D25-JCB User Manual

HM-9350-3
Speed Control Motor and Controller Package
US2
Series
OPERATING MANUAL
Thank you for purchasing an Oriental Motor product.
This Operating Manual describes product handling procedures and safety precautions.
•
Please read it thoroughly to ensure safe operation.
•
Always keep the manual where it is readily available.
D-loop represents the speed control motor which adopted Oriental
Motor's unique technology.
This product achieves high reliability using closed loop control in
addition to downsize the speed controller by digitizing the phase
control circuit.

Oriental motor US2D25-JCB Specifications

General

Brand	Oriental motor
Model	US2D25-JCB
Category	Engine
Language	English

Summary

Safety Precautions

Preparation

Installation

Installation Location Requirements

Motor Installation

Details methods for mounting the motor, including parallel shaft and right angle types.

Load Installation

Load Capacity Specifications

Lists the maximum radial and axial loads the motor/gearhead shaft can withstand.

Speed Controller Installation

Instructions for mounting the speed controller, including orientation and mounting holes.

Connecting

Power Supply Connection

Details how to connect the AC power supply to the speed controller's CN1 terminal.

Motor & Speed Controller Connection

Explains how to connect the motor cable to the speed controller's CN2 connector.

Grounding Procedures

Instructions for grounding the motor and speed controller for safety and protection.

Input Signal Wiring

Operating

Basic Operation Procedure

Step-by-step guide to operating the motor using the front panel controls.

Adjusting Motor Rotation Speed

How to change the motor's speed using the setting dial and operation switch.

Changing Motor Rotation Direction

Instructions on how to switch the motor's rotation direction using the dedicated switch.

Alarms

Alarm Code Reference

Lists common alarm codes, their causes, and reset procedures.

Alarm Reset Procedure

Troubleshooting

No Display or Power Issues

Motor Operation Problems

Speed Setting and Control Issues

Data and Parameter Setting Issues

Specifications

Model and Electrical Specifications