Oriental motor BMUD120-A2

Questions and Answers

M
micheal31Jul 25, 2025
What to do if my Oriental motor BMUD120-A2 does not operate?
- B
  brownaaronJul 26, 2025
  If your Oriental motor Engine does not operate, several factors could be the cause. First, check the connections between the driver and the power supply to ensure they are correctly connected. Second, verify that the operation switch is set to the "RUN" side, not "STAND-BY". If operating the motor using the operation switch, ensure the "external operation signal input" parameter is set to "OFF" after setting the operation switch to the STAND-BY side. When using external signals, the "external operation signal input" parameter should be set to "ON" or "RE" after turning the input operation signal OFF. Also, make sure either the FWD or REV input is ON, but not both. Finally, check for any alarms and reset after addressing the cause.
N
Nicholas HahnJul 30, 2025
Why is my Oriental motor BMUD120-A2 Engine rotating in the wrong direction?
- M
  maryhendersonJul 30, 2025
  If your Oriental motor Engine rotates in the opposite direction to what you specified, there are a few potential causes. First, the FWD and REV inputs might be wrongly or not correctly connected; check these connections. Second, the gear ratio might be causing the gearhead output shaft to rotate in the opposite direction; consult the motor's operating manual for the gearhead output shaft's rotation direction. Also, check the rotation direction switch. Finally, if the rotation direction switch is set to REV, verify the setting of the "external operation signal input" parameter.
T
Tyler LewisAug 3, 2025
What to do if the Oriental motor Engine operation is unstable or vibrating too much?
- M
  Molly KimAug 3, 2025
  If the operation of your Oriental motor Engine is unstable, or if the motor vibration is too great, there are a couple of things you should check. First, make sure that the motor and gearhead output shaft are correctly aligned with the load shaft. Second, check for electrical noise by testing the operation with only the essential equipment (motor, driver, and any other external equipment required for operation). If noise is present, try moving the unit away from noise sources, reviewing the wiring, changing to shielded signal cables, or installing ferrite cores.
M
Megan HebertAug 7, 2025
What to do if I cannot perform settings using the dial on my Oriental motor Engine?
- K
  kimberly14Aug 7, 2025
  If the setting cannot be performed using the setting dial of your Oriental motor Engine, the lock function might be enabled. You should release the lock function.
J
John SantosAug 11, 2025
Why is the set rotation speed not saved on my Oriental motor Engine?
- B
  Brenda ObrienAug 11, 2025
  If the set rotation speed is not being saved on your Oriental motor Engine, ensure that you are confirming the speed by pressing the setting dial after you set it.
E
emilydavisAug 16, 2025
Why is the rotation speed not displayed on my Oriental motor BMUD120-A2 Engine?
- C
  Cory MoodyAug 16, 2025
  If the rotation speed is not displayed on your Oriental motor Engine, the "panel initial view" parameter might not be set to show the rotation speed. Set the "panel initial view" parameter to the rotation speed.
R
Ronnie CantrellAug 19, 2025
Why is my Oriental motor BMUD120-A2 Engine not reversing with the rotation direction switch?
- J
  Jaclyn KramerAug 20, 2025
  If your Oriental motor Engine is not reversed by the rotation direction switch, check the setting of the "external operation signal input" parameter. It may be set to "RE."