DEQ 30‘s power supply is an ultra-quiet balanced high-frequency supply. All power and signal grounds are isolated
for complete noise rejection.
• Power connections made through large four terminal removable connector.
• Connect 12V+ to the battery through fuseholder. This connection provides +12V main power
to the DEQ 30.
• Power wire must be fused less than 18” from battery.
• Ground unit to chassis as close as possible.
• Connect one REM terminal to remote turn-on lead from source unit. This connection provides +12V power to
turn-on the DEQ 30.
• Connect one REM terminal to REM terminals on amplifiers and additional trunk mounted signal processors. This
connection provides +12V to the remote turn-on leads of the amplifiers to amplifiers on.
NOTE: A power reset button located next to the power connections terminal is useful for resetting the
microprocessor in the unlikely event of processor lock up.
SPECIAL NOTE: There is an internal 1.5 AMP AGC fuse located in the DEQ 30. This fuse is designed to blow
only in extreme situations like power surges in the vehicles electrical system. In this type
of situation, the internal fuse serves to protect the DEQ 30 from potential damage.
CORRECTED RESPONSE
9
44
To Next Page
Loading...
