Need help?Do you have a question about the Orion XTR Amplifier XTR5004 and is the answer not in the manual?
General| Brand | Orion |
|---|---|
| Model | XTR Amplifier XTR5004 |
| Category | Car Amplifier |
| Language | English |
Overview of the Orion amplifier line, models XTR2504 and XTR5004.
Overview of the Orion amplifier line, models XTR2504 and XTR5004.
Lists all items included in the amplifier package for setup.
Advice on hearing protection due to high sound pressure levels.
Instructions for recording serial number for warranty and future reference.
Identifies speaker output terminals for channels 1-4.
Details gain and bass boost adjustments for all channels.
Explains RCA input options and line output for system expansion.
Configures input sensitivity for speaker or line level signals.
Manages crossover modes (LPF, FLAT, HPF) and frequency settings.
Lists CEA-compliant power output, signal-to-noise ratio for XTR2504.
Lists CEA-compliant power output, signal-to-noise ratio for XTR5004.
Details power output, signal-to-noise ratio, and distortion levels.
Specifies frequency response, bandwidth, and crossover capabilities.
Covers input impedance, sensitivity, and bass boost features.
Includes dimensions, wire gauge, and protection features.
Covers gain, input/output configurations and line output usage.
Details the active crossover's flexibility and variable frequency adjustments.
Explains the crossover switch for Full Range, High-pass, and Low-pass modes.
Describes the function and range of the low-pass crossover control.
Explains the high-pass crossover function and its variable adjustment range.
Details how to maximize subwoofer performance with bass boost.
Explains subsonic filtering for infinite baffle woofers at 20Hz.
Illustrates the effect of a 20Hz high-pass filter on woofer output and excursion.
Demonstrates the impact of a 30Hz high-pass filter on woofer performance.
Details how to connect power wires, including fusing and grounding.
Explains speaker terminal connections for the amplifier models.
Illustrates wiring for a two-channel bridged amplifier setup.
Details wiring for a four-channel stereo amplifier setup.
Illustrates wiring for a three-channel amplifier setup (2 stereo + 1 bridged).
Details wiring for a tri-mode six-channel amplifier setup.
Guidance on selecting optimal mounting locations for the amplifier.
Specific advice for mounting the amplifier in the passenger compartment.
Recommendations for mounting the amplifier in the trunk for best performance.
Key safety precautions and general tips for a successful installation.
Lists the essential tools needed for amplifier installation.
Determine mounting location and choose the system configuration.
Run wires away from noise sources and connect power, RCA, and speaker terminals.
Pre-drill holes, mount the amplifier securely, and install end caps.
Set crossovers, gain, connect battery, and prepare for system testing.
Steps to verify connections and initial power-up of the amplifier.
Guide to setting amplifier level controls and fine-tuning audio output.
Explains the green Power LED and its meaning during normal operation.
Details the red Protection LED and common causes like short, overcurrent, DC offset.
Explains the red Thermal LED and reasons for overheating, such as ventilation.
Diagram showing the location of Power, Thermal, and Protection LEDs.
Troubleshooting steps for when the amplifier produces no sound output.
Diagnosing issues where audio output intermittently turns on and off.
Resolving problems related to distorted audio output from the amplifier.
Addresses problems with speaker connections and incorrect crossover settings.
Troubleshooting causes for poor bass response, including wiring and crossovers.
Diagnosing and resolving issues related to the main battery fuse blowing.
Details the one-year warranty for units installed by non-authorized dealers.
Outlines the two-year warranty for units installed by authorized dealers.
Lists conditions that void the warranty and disclaims certain liabilities.
To Next Page