Do you have a question about the Orion D5000 and is the answer not in the manual?
Details the limited two-year consumer warranty for the product.
Specifies power output at 4, 2, and 1 ohm loads for both models.
Details low-pass and high-pass crossover options and INTELLI Q.
Details the variable crossover section and INTELLI Q feature.
Details power connection requirements and fuse for WCC-D2400.
Details power connection requirements and fuse for WCC-D5000.
Explains how to connect speakers to the amplifier's terminals.
Guides on bridging the WCC-D2400 with another amplifier.
Provides a step-by-step guide for installing the amplifier.
Outlines steps to test the installed system for proper operation.
Guides on setting level controls and crossovers for optimal sound.
Addresses symptoms and causes for no audio output from the amplifier.
Troubleshoots intermittent audio output due to thermal protection or loose connections.
Identifies reasons for distorted audio output, including gain and impedance.
Details the limited two-year consumer warranty for the product.
Specifies power output at 4, 2, and 1 ohm loads for both models.
Details low-pass and high-pass crossover options and INTELLI Q.
Details the variable crossover section and INTELLI Q feature.
Details power connection requirements and fuse for WCC-D2400.
Details power connection requirements and fuse for WCC-D5000.
Explains how to connect speakers to the amplifier's terminals.
Guides on bridging the WCC-D2400 with another amplifier.
Provides a step-by-step guide for installing the amplifier.
Outlines steps to test the installed system for proper operation.
Guides on setting level controls and crossovers for optimal sound.
Addresses symptoms and causes for no audio output from the amplifier.
Troubleshoots intermittent audio output due to thermal protection or loose connections.
Identifies reasons for distorted audio output, including gain and impedance.
| Channels | 5 |
|---|---|
| RMS Power at 4 Ohms | 50W x 4 + 200W x 1 |
| THD at Rated RMS Power | <0.05% |
| Fuse Rating | 40A |
| Input Sensitivity | 200mV - 6V |
| Impedance | 2 Ohms |
| Frequency Response | 10Hz |












Loading...