17
Monitoring
Displaying Refrigerator State
Displaying Refrigerator State
This unit can display operational data in the digital display on the control panel.
1. Hold down the SET switch on the control plate for 7 seconds to switch the temperature setting
blinking on the digital display to alternate display of "Hr" and the "accumulated operating hours".
2. Press the Temperature Adjustment switch (▲) to display ① and ② → ⑥ and ⑦ in turn, and the
Temperature Adjustment switch (▼) to display ⑦ and ⑥ → ② and ① in turn.
①Alternate display of " " and the "accumulated operating hours" (Unit : 100Hr)
②Alternate display of "
" and the "last alarm"
③Alternate display of " " and the "first alarm before the last"
④Alternate display of "
" and the "second alarm before the last"
⑤Alternate display of "
" and the "third alarm before the last"
⑥Alternate display of " " and the "fourth alarm before the last"
⑦Alternate display of "
" and the "fifth alarm before the last"
3. Press the RESET switch to return to the measurement temperature display.
To Next Page
Loading...
Need help?
General
