What to do if my Orion RKS400F-S Accessories cooler is running but the cooling isn't good?
If the Orion Accessories cooler is running but the cooling capacity is poor, check for a gas leak. If the load is too great, reduce it. If the ambient temperature is too high, lower the cooler ambient temperature to below 40.
How to fix an Orion RKS400F-S Accessories product that doesn’t run and the operation lamp is off?
If the Orion Accessories product doesn’t run and the Operation lamp remains off, the controller may be defective, so replace the controller. Also, the protective device may be defective (refer to protective-device explanations on the next page) or the fuse may be blown, so replace the fuse.
What to do if the Orion RKS400F-S operation lamp is on, but the compressor isn't running?
If the Orion Accessories operation lamp is on, but the compressor is not running, ensure that the power voltage is at the rated level. If the voltage is correct, the electromagnetic contactor might be bad, and you should replace it.
What does the C07 warning on my Orion RKS400F-S mean?
If you receive a C07 - Water temp high/low warning on your Orion Accessories, and the water temperature does not fall to the set temperature, clean the condenser filter and/or reduce the ambient temperature and reduce the load. If the water temperature drops too low when the heat load is low, the temperature may drop 2.0 below the set temperature. There is no problem with the product as long as the temperature rises up again to the set temperature. The warning will automatically be canceled when the water temperature returns to within the set temperature range.
What does error E09 on my Orion Accessories mean?
The R phase is open. Check the power supply and fuse of your Orion Accessories.
What does error E10 on my Orion Accessories mean?
The power supply R, S, and T lines don't match up. Reverse 2 of the 3 lines of the power supply cable of your Orion Accessories.
What does the C00 error mean on my Orion Accessories?
If you are getting a 'C00 - Condenser (filter) inspection warning' on your Orion Accessories, clean the condenser (filter) if it is dirty and then press the reset switch for approximately 5 seconds.
Explains the meaning of hazard, prohibition, and mandatory safety symbols.
Provides crucial warnings and cautions for safe operation.
Details external components and the control panel interface.
Guides users through startup, normal, remote, and dual mode operations.
Outlines weekly, monthly, and half-yearly inspection and maintenance tasks.
Provides guidelines for maintaining water quality to prevent damage.
Covers common issues, error codes, and safety device activations.
Covers essential safety precautions and site selection criteria.
Details correct procedures for water piping and electrical wiring connections.
Lists technical data for RKS400F-S, RKS500F, and RKS750F models.
Shows physical dimensions and port locations for each model.
Provides detailed wiring diagrams for RKS400F-S, RKS500F, and RKS750F.
Details the warranty period, coverage, exclusions, and limitations.
General| Brand | Orion |
|---|---|
| Model | RKS400F-S |
| Category | Accessories |
| Language | English |
To Next Page